29 - Stand

 I spent a hour or two doing a bit more fitting work to the side stand. I started by making a little pin for the spring to hook on to. Then I had to take the head races from my old frame and put them into this one as I needed to put the front wheel in.

 Now that the bike could stand up by itself I cut the stand to a height that allowed the bike to lie at an angle. I didn't want it lying over too far, but not so upright that it would be easily knocked over either. I think I'm happy but maybe I'll get a few other opinions before I weld the foot on.

 Finally I drilled a hole to locate the pin at an angle that was not sticking out too far but kept the spring away from the tyre.